TReX User Manual v2.14 Firmware
Serial Command Configuration
Most items that can be changed via the MENU can also be changed through serial commands.
There are some additional commands that make the TReX more usable when being managed
via a serial connection. These are listed immediately below.
These commands must begin with the character ‘*’ and are processed with a carriage return
character. Any characters before the ‘*’ may result in the command not being processed.
Main Commands
*REBOOT
Forces the unit to immediately restart.
Usage:
*REBOOT<CR>
*CONFIG
Displays current configuration.
Usage:
*CONFIG<CR>
*SAVE
Saves all configuration settings (all configuration changes are restored on start-up).
Usage:
*SAVE <CR>
*LIST
Displays all available commands. This command also lists many specific field names that
need to be used with listed commands.
Usage:
*LIST<CR>
*DEFAULTS
Forces to reset temporary to factory default settings. The user must issue the
*SAVE<CR>
command in order to write these default settings to internal memory.
Usage:
*DEFAULTS<CR>
© WTE Limited, 2018 – Christchurch New Zealand
Page 64 of 158