Using the SFI Menus
ProCam 1500 SFI Manual
15
Ch 3
1095900
TOOL #1
SET COUNTERS
SET CAMS
SET FEED
SET BATCH MODE
SET COUNTER ANGLE
USE CURSOR KEYS TO CHANGE SELECTION
PRESS ENTER TO SELECT, RESET WHEN DONE
Figure 3-9. Selecting "SET FEED" in Program mode
Here is the "SET FEED" display (Figure 3-10). You have up to four choices. The
selections on your screen may vary depending upon your servo feed model.
FEED LENGTH
ACCELERATION
MAX RUN SPEED
FEED ADVISOR
2.252
10
1,155
USE CURSOR KEYS TO MAKE SELECTION
PRESS ENTER TO SELECT, RESET WHEN DONE
INCHES
%
IN/MIN
FEED PARAMETERS FOR TOOL #1
Figure 3-10. Feed settings
Read your servo feed manual before making settings
Consult your servo feed manual for any requirements you must meet for
feed length and other settings. Remember, ProCam 1500 does not change
the way your servo feed operates or any parameters or limitations built
into your servo feed. Be sure you have read your servo feed manual and
understand how your servo feed works before making any settings.
Feed settings
When you select "Feed length", a new display appears that allows you to set this value.
See Figure 3-11.
0002.252
USE LEFT / RIGHT CURSORS TO SELECT DIGITS
USE UP / DOWN CURSORS TO CHANGE VALUES
PRESS ENTER WHEN DONE, RESET TO CANCEL
FEED LENGTH
Figure 3-11. Setting Feed length
