Using the SFI Menus
ProCam 1500 SFI Manual
14
Ch 3
1095900
USE CURSOR KEYS TO CHANGE SELECTION
PRESS ENTER TO CHANGE, RESET WHEN DONE
LOAD TOOL #:
ADJUST CAMS:
ADJUST COUNTERS:
RESET MODE:
ADJUST FEED:
PROGRAM AND RUN MODES
PROGRAM AND RUN MODES
PROGRAM AND RUN MODES
PROGRAM AND RUN MODES
PROGRAM AND RUN MODES
Figure 3-7. Security Access display
To lock out the action so it cannot be taken in Run mode, press the ENTER key. The
setting is now locked out. You will see the words "Program mode only" next to the
action.
You will now see this display.
USE CURSOR KEYS TO CHANGE SELECTION
PRESS ENTER TO CHANGE, RESET WHEN DONE
LOAD TOOL #:
ADJUST CAMS:
ADJUST COUNTERS:
RESET MODE:
ADJUST FEED:
PROGRAM AND RUN MODES
PROGRAM AND RUN MODES
PROGRAM AND RUN MODES
PROGRAM AND RUN MODES
PROGRAM MODE ONLY
Figure 3-8. Locking out "Adjust feed"
The feed controller can now be adjusted in the Program mode only. If you do not want to
make a change, press RESET to go back to the Initialization menu.
Program mode
Go into Program mode, by turning the Program/Run key to "Run" and then back to
"Program". Next, select a tool number to modify, and then select "Modify the tool
number information". If you are not sure how to do this, refer to Chapter 5 in the
ProCam 1500 user manual.
SELECT = HIG ENTER
When we say SELECT in this manual, it means use the cursor keys
to highlight the item and press ENTER. See Chapter 3 in the
ProCam 1500 user manual for more information.
Once you have selected a tool to modify, you will see a display which lists the various
settings you can make for the tool. Select "Set feed", as shown in Figure 3-9.
