Winterhalter PT-L, Operating Instructions Manual

Page: 5 / 44

Safety notes
3
2.3 Electrical Safety

The electrical safety of this machine is guaranteed only if it is connected to a correctly installed
protective circuit and a residual current circuit breaker. It is very important that this basic safety
requirement is tested and in case of doubt the house installation is checked by a qualified elec-
trician.
Winterhalter cannot be held responsible for damage caused by a missing or broken earthing
system (e.g. electrical shock).
2.4 Safety Instructions for Maintenance and Repairs

Maintenance work and repairs may only be performed by service technicians authorised by
Winterhalter. Improper maintenance or repairs may cause significant danger for the user, for
which Winterhalter is not liable.

When performing maintenance and repair work, unplug machine from the power network. Elec-
tricity consumers (heating element, frequency inverter, ...) are under voltage until the on-site
mains disconnect switch has been operated.

Only original Winterhalter spare parts may be used for maintenance and repairs. If original
spare parts are not used, the warranty is invalidated.

A damaged or leaking machine can endanger your safety. In case of defects, switch off the ma-
chine immediately. Switch off the on-site mains disconnector (main switch). Only then is the
machine without power.

Do not operate a damaged machine. In case of defects resulting from an unknown cause,
switch off the machine, and do not switch it on until the defect has been rectified.

Contact your installer or electrician if the on-site water or electricity supply is the cause of the
malfunction.

Notify an authorised service technician or your retailer if another fault has occurred.

If the mains cable of this machine is damaged, it must be replaced by the Winterhalter or its
Customer Service or another qualified person in order to prevent hazards. The mains cable
must be H07 RN-F type or equivalent.
2.5 General safety notes

Read through the safety notes and operating instructions in this manual carefully. Retain the
operating instructions for future reference. Winterhalter Gastronom GmbH does not assume lia-
bility or warranty in case of non-adherence to these safety and operating instructions.

Do not make changes, additions or reconstructions in the dishwasher without the approval of
the manufacturer.

Do not transport the warewasher with the ClimatePlus heat pump installed. The centre of gravity
is situated on the right side and the warewasher could tip over.

Use the dishwasher only after you have read and understood the operating manual. Allow the
Winterhalter Customer Service to provide information about the operation and functioning of the
dishwasher. Always operate the machine as described in these operating instructions.

Train the operating personnel as regards handling the machine and inform them about the safe-
ty notes. Repeat the training sessions at regular intervals to prevent accidents.

For your safety, test the local fault current circuit breaker (FI) regularly by pressing the test but-
ton.

Close the on-site water stop cock after the work is complete.

Switch off the local mains disconnector after the work is complete.