![background image](http://html1.mh-extra.com/html/winnebago/reoy/reoy_owners-manual_987507082.webp)
SECTION 7 –
PLUMBING
7-10
NOTE: If Waste Pump stalls, check breaker in
the load center. If problem persists,
remove end cap and manually turn pump
shaft (located on the end of the Waste
Pump) with a screwdriver.
Waste Pump Access
Further Information
For further information and operating
cautions, see the Waste Pump manufacturer’s
user guide provided in your InfoCase.
Dumping Holding Tanks
1. Remove sewage drain hose from cylindrical
compartment near water service center or LP
fill, depending on model.
2. Remove dust cap from sewage drain outlet
and connect sewage drain hose. Be sure it is
firmly attached.
3. Place the outlet end of sewage drain hose into
disposal opening.
4. Open the Black Waste Tank Drain valve with
a quick pull and make sure there are no sags in
the hose. Move the hose gently about to
dislodge any waste and ensure complete
drainage. Close Black Waste Tank Drain
valve as soon as tank is empty.
NOTE: DO NOT OPEN BOTH VALVES AT
ONCE. Do not open the Gray Waste Tank
Drain valve until the black tank is
drained and dump valve closed to avoid
Waste Pump
(Located behind removable
panel in water service center)
-Typical View
Waste Pump Access
(Located behind removable
panel in water service center)
Manual Pump
Access
Sewage Drain Outlet
(Located in driver side compartment)
-Typical View
Dust Cap
Black Waste Tank Drain Valve
(Located in driver side compartment)
-Typical View
1st - Pull Black
Waste Tank Drain
Valve to drain
black water
(sewage) tank.