![background image](http://html1.mh-extra.com/html/winnebago/reoy/reoy_owners-manual_987507077.webp)
7-5
SECTION 7 –
PLUMBING
COLD WATER FILTER
–If Equipped
To obtain filtered cold water for drinking or
cooking, simply open the galley sink cold water
faucet.
NOTE: Only the cold water faucet is filtered.
The cold waterline flows through an activated
carbon filter that removes chlorine and odors for
taste-free drinking water.
Replacing the Cold Water Filter
Cartridge
You should replace the filter cartridge every
season and when water flow from the faucet is
too slow for convenience. The cartridge must be
replaced at least every 12 months.
•
Place a container beneath the filter to catch
any water remaining in the waterlines during
filter removal.
•
Twist the filter cartridge “counter-clockwise”
about one-quarter turn, then pull it down and
out of the filter socket.
•
Insert a new water filter cartridge up into the
filter socket as far as possible and twist it
“clockwise” one-quarter turn until it stops.
Water Pump
-Typical installation shown
•
Model 25P
- Located beneath removable
panel in rear corner bed.
•
Model 25T
- Located behind removable
access panel in rear driver side
compartment.
•
Model 25Q
- Located beneath
removable access panel under rear bed
board.
Cold Water Filter Assembly
(Located below galley sink)
NOTE: Hot waterline is not filtered.
• Insert new filter up into filter socket -
press and twist 1/4 turn “clockwise”.