SECTION 3 –
DRIVING YOUR MOTORHOME
3-2
•
Tip the seat rearward until the lock pin clears
the floor plate locking ramp, then re-lock the
Locking Arm to avoid bending.
•
With the seat tilted slightly rearward, remove
the seat assembly by lifting it up and forward.
Installing Companion Seats
The following label is located on the
Companion Seats:
•
With the seat tilted slightly rearward, lower
the Pedestal/Seat Assembly Rear Hooks into
the pockets in the floor plate.
•
Push DOWN on the Safety Lock and rotate
the Locking Arm COUNTER-CLOCKWISE
(to the unlocked position). Align the lock pin
to allow it to pass through the floor plate at the
locking ramp.
•
Push DOWN on the front of the seat and rotate
the Locking Arm slightly to ensure that the
lock pin is engaged under the locking ramp.
•
Rotate the Locking Arm CLOCKWISE (to
the locked position), ensuring the Locking
Arm is captured by the Safety Lock.
WARNING
Engage rear hooks in floor plate with
locking arm captured by safety lock.
Failure can result in death or injury. Refer
to operator manual.
Floor Plate
Rear Hooks
(insert into
floor plate
pockets)
