![background image](http://html1.mh-extra.com/html/winnebago/2009-adventurer/2009-adventurer_operators-manual_987444125.webp)
10-15
SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
•
DO NOT OPEN THE JACK VALVES ON
THE RESERVOIR SIDE OF THE PUMP.
These regulate the coach leveling jacks.
•
Apply a steady inward pressure of
approximately 150 lbs. to the exterior
sidewall of the slideout room to push the room
in toward the coach until it is snug against the
main coach sidewall.
NOTE: Use some type of rigid, padded material
to protect the sidewall from punctures,
dents, or other damage to the finish from
any device or equipment used to press
the sidewall in.
•
Pressure must be applied evenly to avoid
binding of the hydraulic mechanism. It may
take about 10 minutes to press the room
extension inward completely.
•
When the room is snug against the coach wall,
close the solenoid valves to prevent “creep
out” during transit.
See your authorized Winnebago Industries
®
dealer for service of the slideout system before
using again.
NOTE: When the system has been corrected,
check hydraulic fluid level and refill
reservoir as necessary. Press the Retract
switch for 15 to 20 seconds before
attempting to extend the room. Run the
room out and in several times to purge
any air from the hydraulic system.
Finally, recheck fluid level and fill as
necessary.
Further Information
See the Hydraulic Leveling System/Room
Extension Operator’s Manual in your InfoCase
for further instructions and troubleshooting
information.
SLIDEOUT EMERGENCY
RETRACTION - BEDROOM
-If Equipped
Crank-In Procedure
•
Locate the tools in the right front side storage
compartment - a ratchet wrench, a hex-end
shaft, and an extension shaft. (The ratchet
wrench may be packaged in the InfoCase).
•
Locate the small, round access hole in the bed
base at the foot of the bed.
•
Attach the shaft extension to hex-end shaft
and place the ratchet wrench onto the hex end
shaft, then insert into the hole in the bed base
as shown.