![background image](http://html1.mh-extra.com/html/winnebago/2009-adventurer/2009-adventurer_operators-manual_987444120.webp)
SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
10-10
SLIDEOUT ROOM
TROUBLESHOOTING –
HYDRAULIC
If Slideout Room Will Not Operate
•
The chassis battery may be low on charge.
The engine should be running while extending
or retracting slideout rooms so the engine
alternator can provide maximum power to
properly operate the slideout mechanisms.
If battery charge is sufficient, go to next step.
•
A fuse may be blown in the hydraulic system
control box on the pump, which can be viewed
from beneath the chassis near the left or right
front wheel. See following illustration.
See the Leveling System/Room Extension
Operator’s Manual in your InfoCase for
control box fuse replacement information.
If no fuses are blown, go to the next step.
•
If the batteries and fuses are okay, there may
be a failure in the hydraulic control system or
electrical system, which requires service.
Retract the room using the following
emergency retract procedures and contact
your dealer for service.
SLIDEOUT EMERGENCY
RETRACTION – ELECTRIC
(Front Slideout Room)
-If Equipped
Crank-In Procedure
If the slideout mechanism is malfunctioning
and will not retract using the buttons, you will
need to manually crank the room in to the travel
position.
NOTE: The room can also be cranked out into
the extended position using this method,
if necessary.
The slideout crank tools are stored in clips on
the wall of an exterior storage compartment.
The crank sockets are located behind the
exterior storage compartment doors below the
ends of the room.
WARNING
Stop engine, place transmission in
neutral position, and apply parking brake
before lying beneath vehicle for this
procedure.
Hydraulic System Control Box
(on pump beneath chassis near LH or RH front tire)
Slideout Cranks (Typical View)