![background image](http://html1.mh-extra.com/html/winnebago/2009-adventurer/2009-adventurer_operators-manual_987444123.webp)
10-13
SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
Room Extension Operator’s Manual
included in your InfoCase for
identification of slideout and leveling
jack solenoids.
The manual provides specific
instructions on which valves to open for
front or rear slideout rooms and what
additional precautions to follow.
The solenoid valves have a small 1/4”
nut at the end of the valve shaft that
requires you to use a 1/4” nut driver built
into the shaft of the oil reservoir
breather/fill cap. See following photo.
NOTE:Always clean away any dirt and debris
from the top of the reservoir before
removing the breather cap to avoid entry
of debris and contamination of hydraulic
oil in the reservoir, which could lead to
pump failure or other problems.
•
Open the slideout solenoid valves to relieve
hydraulic line pressure.
DO NOT LOOSEN
NUTS MORE THAN 4 FULL TURNS.
•
Do not open leveling jack solenoids
.
Step 2: Crank the Room Inward
•
A wrench is used to crank the room inward.
You may use the ratchet wrench supplied with
the coach (in one of the storage
compartments) or any type of wheel lug
wrench for the same size bolt head.
•
Retract bolts are located on the outboard
mounting plates of the slideout room as
shown. These plates are located at both ends
of the room inside the compartment doors.
•
Loosen the lock screws near the retract bolts
as shown before trying to turn the bolts.
Use 1/4” nut driver built into end of pump
reservoir cap to open slideout solenoid valves
Use provided 1/4” nut driver to turn nut
counter-clockwise 4 turns only
Slideout Room Solenoid Valve
Leveling/Slideout System Hydraulic Pump
(Note valve positions in relation to fluid reservoir)