10-1
5 - DASH / AUT
O
SECTION 10 – SLIDEOUT ROOMS AND LEVELING
SLIDEOUT ROOM TRAVEL
LOCKS
–If Equipped
Some models are equipped with electric
powered travel locks on slideout rooms to restrict
movement of the slideout room while the vehicle
is in motion. The room will not extend until the
lock is fully released.
Slideout Lock switches are located near the
slideout control switches on the dash or on a wall
in an area near the slideout room.
NOTE: Be sure locks are fully released before
attempting to extend or retract room.
If the latch mechanisms are protruding
more than 1/4”, the room will not extend
or retract and the slideout hydraulic
pump will run in idle/bypass mode.
To Release:
•
Press and hold the “unlock” side of the
Slideout Lock switch for about 7 seconds.
(You may be able to hear the lock motor sound
stop).
To Lock:
•
Press and hold the “lock” side of the Slideout
Lock switch for about 7 seconds. (You may be
able to hear the lock motor sound stop).
SLIDEOUT ROOM TRAVEL
LOCK
–If Equipped
Some models are equipped with an
expandable prop-lock rod device to restrict
movement of the slideout room while the vehicle
is in motion.
The Lock Rod
must be released before
extending the room
or damage to the coach will
result.
To Release Lock Rod:
•
Rotate the body of the cylinder to loosen and
remove lock rod.
CAUTION
Release Slideout Lock before attempting
to extend slideout room. The room will not
extend until the lock is fully released.
Fasten Slideout Lock before driving
vehicle. See following instructions.
Slideout Room Locks (Typical View)
Your model may be equipped with one or
more types
CAUTION
Release and remove Slideout Prop-Lock
Rod before attempting to extend slideout
room. Damage to the vehicle will result if
this is not done. Position and secure
Prop-Lock before driving vehicle. See
following instructions.