M-Series HMI
vi
Safety Precautions
For your safety carefully read all the safety instructions before using the device. Keep
this user manual for future reference.
Always disconnect this equipment from any AC outlet before cleaning. Do not
use liquid or spray detergents for cleaning. Use a damp cloth.
For pluggable equipment, the power outlet must be installed near the
equipment and must be easily accessible.
Keep this equipment away from humidity.
Put this equipment on a reliable surface during installation. Dropping it or letting
it fall could cause damage.
The openings on the enclosure are for air convection and to protect the
equipment from overheating.
CAUTION/ATTENTION
Do not cover the openings!
Ne pas couvrir les ouvertures!
Before connecting the equipment to the power outlet make sure the voltage of
the power source is correct.
Position the power cord so that people cannot step on it. Do not place anything
over the power cord.
If the equipment is not used for a long time, disconnect it from the power
source to avoid damage by transient over-voltage.
Never pour any liquid into an opening. This could cause fire or electrical shock.
Never open the equipment. For safety reasons, only qualified service personnel
should open the equipment.
All cautions and warnings on the equipment should be noted.
*
Let service personnel to check the equipment in case any of the following
problems appear:
o
The power cord or plug is damaged.
o
Liquid has penetrated into the equipment.
o
The equipment has been exposed to moisture.
o
The equipment does not work well or you cannot get it to work
according to the user manual.
o
The equipment has been dropped and damaged.
o
The equipment has obvious signs of breakage.
Do not leave this equipment in an uncontrolled environment where the storage
temperature is below -20°C (-4°F) or above 60°C (140°F). It may damage the
equipment.
Summary of Contents for R12IBWS-MHM2
Page 18: ...USER MANUAL CHAPTER 1 INTRODUCTION M SERIES HMI 5 1 4 1 Dimensions 15 Unit mm...
Page 19: ...USER MANUAL CHAPTER 1 INTRODUCTION M SERIES HMI 6 1 4 2 Dimensions 17 Unit mm...
Page 20: ...USER MANUAL CHAPTER 1 INTRODUCTION M SERIES HMI 7 1 4 3 Dimensions 19 Unit mm...
Page 21: ...USER MANUAL CHAPTER 1 INTRODUCTION M SERIES HMI 8 1 4 4 Dimensions 21 5 Unit mm...