iv
CE Notice (European Union)
This device has been tested and found to conform to the limits set for a Class B product.
• EN 55022 — “Limits and Methods of Measurement of Radio Interference Characteristics of Information
Technology Equipment”
• EN 55024 — “Information technology equipment - Immunity characteristics - Limits and methods of
measurement”
• EN 61000-3-2 — “Electromagnetic compatibility (EMC) - Part 3: Limits - Section 2”
• EN 61000-3-3 — “Electromagnetic compatibility (EMC) - Part 3: Limits - Section 3”
• EN 60950 — “Safety of Information Technology Equipment”.
• EN 55022 Emissions requirements
RF Exposure Information (SAR)
This device is compliance with SAR for general population /uncontrolled exposure limits in ANSI/IEEE C95.1-1999
and had been tested in accordance with the measurement methods and procedures specified in OET Bulletin 65
Supplement C.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device
was tested for operations with the device contacted directly to the human body to the back side of the EUT. To
maintain compliance with FCC RF exposure compliance requirements, avoid direct contact to the transmitted antenna
during transmitting.
IC Regulations
Le présent appareil est conforme
aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
(1)
l’appareil ne doit pas produire de brouillage, et
(2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.”
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.