Installation
There are two mounting options for the Winegard Gateway system:
A. Ceiling Mount (recommended) or B. Inside Air 360
+
Dome.
If the Air 360
+
system was installed at the RV
manufacturer, you may notice a white circular Winegard
cable access cap on the ceiling of your RV. If the Air 360
+
was not previously installed, refer to the Air 360
+
Installation
instructions before attempting to mount the Gateway system.
NOTE:
When mounting the Gateway inside the RV, it MUST be mounted
directly under the Air 360
+
to ensure the WiFi and 4G LTE antenna cables
reach the Gateway.
Step 1
- Remove the two screws that secure the access cap to the ceiling
and gently pull the +12VDC power cables and three smaller antenna cables
down through the hole. If any of these cables are missing please contact
Winegard Company.
Step 2
– Pull the cables
through the guide hole of
the mounting bracket and
align this hole with the hole
in the ceiling of the RV.
Make sure that the bracket
is in a parallel position
with the walls of the RV.
Once in position, secure
the mounting plate to the
ceiling of the RV with four
screws included in the
mounting hardware.
see page 5 for diagram
A. Ceiling Mount Install (Recommended)
Line up
with hole
in ceiling
Front of R
V
2
Guide hole
