Windsor 10086130, Operating Instructions Manual, Page: 20 / 136

MACHINE OPERATION
86292490 VOYAGER DUO 08/20/07
3-12
FILLING SOLUTION TANK
FOR SAFETY: Before leaving or servicing
machine; stop on level surface, turn off machine
and remove key.
1. Turn the machine power off.
2. Remove the front cover and the solution fill lid.
3. Fill the solution tank with clean water. (See the
Technical Specifications chart for exact
capacity). The water must not be hotter than
140
°
F (60
°
C) to prevent damage to the tank.
4. Replace the solution fill lid and front cover.
DELUXE
1. Turn the machine power off.
2. Remove the front cover and the solution fill lid.
3. Fill the “A” tank with either encapsulating
interim carpet cleaning or prespray chemical.
4. Fill the “B” tank with extraction chemical.
5. Turn machine power on.
6. Prime chemical system by holding the prime
switch to the “A” position for 30 seconds then
holding the prime switch to the “B” position for
30 seconds. If using only one chemical tank,
prime only that system.
Flammable materials
can cause an
explosion or fire. Do not use flammable
materials in the tanks.
NORMAL SCRUBBING
Plan the scrubbing pattern in advance.
For efficient operation, the runs should be the
longest possible without turning, stopping, or raising
or lowering scrub deck. The longest track is around
the perimeter of the area to be cleaned and a
collapsing rectangle pattern is most efficient.
In order to achieve the best possible results, the
area which is to be cleaned, should be vacuumed
before scrubbing. Large debris, strings and wire
must be removed to prevent being caught in
brushes.
If the machine is allowed to stand in neutral with the
scrub deck down for more than 2 seconds, the
solutions flow stops and brush motor stops. When
forward travel is resumed, the solution flow and the
scrub brush motor will continue. Overlap the brush
path and avoid transporting over previously cleaned
areas.
RECOMMENDED SCRUBBING PATH