Windsor 10086130, Operating Instructions Manual, Page: 18 / 136

SCRUB CONTROLS
86292490 VOYAGER DUO 08/20/07
3-10
SCRUB DECK ROTARY SWITCH (DELUXE)
Raises and lowers the scrub deck, and turns the scrub brush motors on and off, and controls the
solution solenoids.
For interim/pre-spray “A” mode, rotate the function knob to the “A” position. The “A” chemical will be
drawn from its tank and delivered to the solution system. The scrub deck will lower and the scrub
motor will turn on and the interim/pre-spray solenoid will open and spray will flow through the jets.
The brush motor will automatically turn off in neutral. The spray solenoid will shut off in neutral or
reverse.
To raise the deck, turn off the brush motor and solenoid(s). Rotate the knob to the off position to the
far counter clockwise position.
For extraction or “B” mode, rotate the function knob to the “B” position. The “B” chemical will be drawn
from its tank and delivered to the solution system. The scrub deck will lower and the scrub motor will
turn on and the extraction solenoid and interim/pre-spray solenoid will open and spray will flow
through the extraction and interim jets and the vacuum motor will run. The brush motor will
automatically turn off in neutral. The extraction and interim/pre-spray solenoid will shut off in neutral
or reverse.
To raise the deck, turn off the brush motor and solenoid(s). Rotate the knob to either the off position
to the far counter clockwise position, or rotate the knob to the far clockwise position to the accessory
mode so that the vacuum motor continues to run to keep any excess soiled solution from dripping
back onto the floor.
To use the machine with an accessory hand tool or wand rotate the knob fully clockwise to the
accessory position. Only the vacuum motor and pump will run. Connect the solution hose of the
accessory tool to the solution accessory port. The fitting is 1/8” male quick disconnect. If needed to
adapt to 1/4” male quick disconnect (see Suggested Spare Parts for part number).
NOTE: The
accessory port is only supplied with water from the solution tank. No chemical is injected.
To connect the vacuum hose, open the accessory port cover and insert the wand vacuum hose fully
into the port.