41
8.
For the service technician/heating technician
Actuator test
LogWIN
Heating circuit 1
Heating circuit 2
Buffer load/switching
8.3 Actuator test
In the actuator test, different actuators can be tested.
WARNING
Only trained service personnel may perform the actuator test.
Navigate to the actuator test by pressing the menu button
→
Actuator test
. The installed and connected
function modules or the boiler to be selected are displayed.
The following actuators can be started with LogWIN.
– Induced draught blower
– Primary airflap
– Secondary airflap
– O2 heating
– Ignition
The actuators are turned off again automatically after a timeout without actuations. A self-test is started at the end of
an actuator test.
When this icon is pressed, the following actions are performed:
Actuator ON
Actuator OFF
Actuator OPEN
Actuator CLOSED
Actuator release
Mo 05.10.2015 / 08:00
Chimney sweeper
Heating programs
DHW program
Actuator test
Operator level
Boiler ON/OFF
Messages
Basic settings
LogWIN
75
°C
Modulation mode
Information level
Fig. 81 Homescreen
Fig. 82
Fig. 83
Fig. 84
Information
Boiler in operation! Do you want to start the actu-
ator test? This can take 20 min.
Operating phase: Burnout
OK
Cancel
Summary of Contents for INFOWIN TOUCH
Page 43: ......
