Wincor Nixdorf TH250, Programmer'S Manual

Page: 62 / 182

TH250 Programmer’s Guide
57
Default: 0 (Cancel)
Prints upside-down characters until the printer is initialized, reset, or powered off. The command
may be combined with clockwise rotated print (1B 56) or counter-clockwise rotated print (1B 12).
The character order is inverted in the buffer so text is readable. Only bit 0 is used. Bits 1-7 are not
used. See summary of rotated printing in this document for more information.
Exceptions
The command is valid only at the beginning of a line. It cannot be used with right side up
characters on the same line.
Select character size
ASCII GS! n
Hexadecimal 1D 21 n
Decimal 29 33 n
Value of n : 1–8 = vertical number of times active font
1–8 = horizontal number of times active
font
Range of n : 00–07, 10–17, ...70–77
Default: 11 hexadecimal
Selects the character height using bits 0 to 2 and selects the character width using bits 4 to 6, as
follows: With smoothing enabled, maximum value of 0 +
n is 66.
Character width selection
Hex
Decimal Width
00 0 1 (Normal)
10 16 2 (two times width)
20 32 3 (three times width)
30 48 4 (four times width)
40 64 5 (five times width)
50 80 6 (six times width)
60 96 7 (seven times width)
70 112 8 (eight times width)
Character height selection
Hex
Decimal Height
00 0 1 (Normal)
01 1 2 (two times height)
02 2 3 (three times height)
03 3 4 (four times height)
04 4 5 (five times height)
05 5 6 (six times height)
06 6 7 (seven times height)
07 7 8 (eight times height)