Wincor Nixdorf TH250, Programmer'S Manual

Page: 113 / 182

TH250 Programmer’s Guide
108
Print data in page mode
ASCII
Hexadecimal
Decimal ESC FF
1B 0C
27 12
Collectively prints all buffered data in the printing area.
After printing, the printer does not clear the buffered data and sets values for select print direction
in page mode (1B 54 n) and set print area in page mode (1B 57 …), and sets the position for
buffering character data.
Printer returns to standard mode through use of 0C, 1B 53, or initialization (which cancels all
settings).
Exceptions
This command is enabled only in page mode.
Select page mode
ASCII
Hexadecimal
Decimal ESC L
1B 4C
27 76
Switches from standard mode to page mode. After printing has been completed either by the
print and return to standard mode (FF) command or select standard mode (1B 53) the printer
returns to standard mode. The developed data is deleted after being printed. For more
information see page mode in this document.
This command sets the position where data is buffered to the position specified by select print
direction in page mode (1B 54) within the printing area defined by set print area in page mode (1B
57).
This command switches the settings for the following commands (which values can be set
independently in standard mode and page mode) to those for page mode.

Set right-side character spacing (1B 20)

Select 1/6-inch line spacing (1B 32)

Set line spacing (1B 33)
It is possible only to set values for the following commands in page mode. These commands are
not executed.

Select or cancel 90 degree clockwise rotation (1B 56)

Set counter-clockwise rotation (1B 12)

Select justification (1B 61)

Select or cancel upside-down printing (1B 7B)

Set left margin (1D 4C)

Set print area width (1D 57)
The table below shows the difference in memory allocation in page mode when using
monochrome and two-color paper. Two-color paper mode requires extra memory in order to
differentiate between non-black and black.