Wincor Nixdorf CINEO C4080, Installation Manual

Page: 15 / 194

Introduction Important safety precautions
01750223447 D CINEO C4080 - Installation Guide
3
When moving the device from a cold to a warm environment, do not
operate it for at least two hours to prevent possible damage caused by
condensation.
Only use the original packaging material to transport the device.
Note the warning and information labels on the device.
Unless otherwise stated, grasp the components only by the green ledge
when handling them.
The device is equipped with a safety-tested power cable which must be
connected only to a suitable grounded outlet.
Always hold the plug when removing the power cable. Never pull the cable
itself.
Install cables in such a way that they will not be stepped on or tripped over
or damaged or crushed in any way.
Have damaged power cables replaced immediately.
Make sure that there is always free access to the sockets used or to the
electrical circuit-breakers of the house installation.
In case of an emergency (e.g. damaged cabinets, controls or power cables,
liquids or foreign objects in the device) take the following steps:
Deactivate the device immediately by:
Switching off the automatic circuit-breaker or removing the fuse inset
from the fuse holder in the distribution box of the building installation;
Disconnecting the plug connector of the power supply cable from the
grounded socket in the building installation;
Switching off the ON/OFF switch on the power distributor;
Interrupting the power connection, if there is one, between the UPS
(uninterruptible power supply) and the device (see chapter
“Introduction” section "General power interrupt" in the operating
manual);
During a thunderstorm, data transmission lines must not be connected or
disconnected.
Always keep the device's vents free from obstruction to ensure proper air
circulation and to prevent malfunctions resulting from overheating.