Wilton 8014FW, Operating Instructions And Parts Manual

Page: 13 / 56

13
3. Tighten the socket head cap screws
securely.
4. This procedure should be done for both
upper and lower guide housings.
5. Open upper door and rotate the wheel by
hand until the weld portion of the blade is
between the two blade guides.
6. Loosen the socket head cap screws (Figure
9) on the blade guides.
7. Move the blade guides so they are as close
to the blade as possible without touching it.
8. Tighten the socket head cap screws (Figure
9). Make sure the air nozzle is still directed
properly toward the cutting area.
9. This procedure should be done for both
upper and lower blade guides.
As the blade guides receive use, they will
become worn at the front end. If the blade
guides become difficult to adjust, switch the left
and right blade guides (Figure 10).
The stopper positioned behind the back edge of
the blade (Figure 10) will also become worn with
use, and the friction of the shaft with the saw
blade may cause lines in the surface of the
stopper. If this occurs, loosen the socket head
cap screw, and rotate the stopper to either side
to change its position on the blade. Re-tighten
socket head cap screw.
Squaring Work Table with Blade
1. Place the table in horizontal position with “0”
on the scale.
2. Place a machinist’s square on the table and
against the blade, as shown in Figure 11, for
side-to-side squaring of the table. Place the
square against the edge of the blade for
front-to-back squaring.
3. If the square is not flush against the blade,
loosen either set of socket head screws
below the table (Figure 12) with a hex
wrench (provided). Make adjustments as
necessary, and tighten the screws.
4. Make sure the pointer is set at “0” on both
scales. If it needs slight adjustment, loosen
the screw and shift the pointer until it aligns
with “0”. Re-tighten the screw.
Figure 10
Figure 11
Figure 12