Wilton 8014FW, Operating Instructions And Parts Manual

Page: 25 / 56

25
Troubleshooting – Operating Problems
Trouble Probable Cause Remedy
Blade has been improperly welded.
Re-weld the blade (see page 16-
19).
Blade not installed properly.
Set the blade guides closer, and
increase blade tension.
Feeding workpiece too forcefully. Decrease feed rate.
Saw blade is
twisted.
Incorrect choice of blade.
Use a proper width blade for radius
or wavy line cutting.
Blade tooth has improper set. File to proper set or replace blade.
Not enough blade tension. Increase tension.
Guide post too high.
Set guide post closer to the
workpiece.
Cuts not straight.
Feed rate too strong. Decrease feed rate.
Blade not tensioned enough. Increase tension.
Blade slips off
wheel(s).
Wheels not aligned properly.
Contact technical service for
adjustment of wheel alignment.
Blade speed too fast. Use slower speed.
Wrong blade for the job. Use proper blade for workpiece.
Blade quickly
becomes dull.
Feed rate excessive. Decrease feed rate.
Dull blade. Sharpen or replace blade.
Guide post not fixed properly. Fix guide post in position.
Blade not tensioned enough. Increase tension.
Blade warps.
Blade not 90° to table.
Adjust table perpendicular to blade
(see page 13).
Band Saw not resting on level
surface.
Floor must be flat.
Band Saw is noisy,
or vibrates too
much.
The variator pulley is damaged. Replace pulley.
Incorrect blade for the job. Select proper blade pitch and style.
Blade teeth keep
breaking.
Blade is of inferior material. Use better quality blade.
The blade has been over-annealed. Decrease annealing temperature.
Too large a gap between blade
guides and blade. Adjust proper gap between guides
and blade (see page 13).
Blade becomes
damaged easily.
Blade too wide for short radius
cutting. Select narrower blade appropriate
to the job.