9
10
Contact Wilson Electronics Customer Support Team with any questions at 866-839-9361
or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.
Post Install Setup
The Pro Series booster is designed with advanced internal programming which allows it
to automatically adjust itself for a variety of conditions and still boost weak signals . After
completing the amplifier installation, the LCD display and push button on the lower panel
of the Pro Series booster is used to verify the final gain that the booster adjusted itself to
produce after antennas have been placed . The display can also be used (if necessary) to
re-adjust antennas so the booster can produce maximum gain and therefore, coverage .
The LCD screen will show status for each band and inform the installer if any bands may
have had their gain reduced by the booster’s internal programming . In addition, an indicator
light on the booster's upper panel will help diagnose the overall status of the booster by
glowing in different colors . This will be covered in the following page .
The Pro Plus booster has an integrated graphical meter to simplify the installation process .
This is not to replace your signal meter - rather it complements the use . The bar graphs
will assist in the aiming of your outside antenna - the biggest graph indicates that you are
receiving the best overall signal .
To access this feature for the currently displayed frequency band, press and hold the "Band
Select" button for 2 seconds . This will change the display to the UL/DL bar graph (uplink/
downlink) . A quick press of the button will move to the next band (briefly showing the band,
before returning back to the bar graph); while holding the button will return to the regular display .
UL
DL
press and hold
for 2 seconds
Understanding the LCD Screen
1 . Four bands can be individually selected:
The 700 MHz LTE Bands (B12/17 and B13)
OK
The 800 MHz Band
– Cell Band
The 1900 MHz
– PCS Band
1700/2100 MHz
– AWS Band
OK
OK
OK
