1
2
Contact Wilson Electronics Customer Support Team with any questions at 866-839-9361
or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.
Inside this Package
Note:
Kits may contain different accessories
Signal
Booster
AC/DC
Power Supply
12V/3A
(859900)
2’ LMR 400
(952302)
Lightning Surge
Protector
(859902)
To purchase Expansion Kits call Wilson Electronics Sales Department at:
888-503-5329
For additional antenna options see pages 14 & 15.
1 . Select a location on the roof or outside of the building to install the outside
antenna . Refer to pages 3 & 5 .
2 . Select a location to install the Signal Booster that is away from excessive heat,
direct sunlight or moisture, and has adequate ventilation . Airtight enclosures
are not recommended . Booster should be as close to the outside antenna as
possible in order to minimize losses from cable length to outside antenna .
3 . Connect the cable from the outside antenna to the signal booster’s “outside
antenna” connector . Refer to page 6 for more information on running cable .
Lightning Surge Protection is recommended for all in-building installations .
Refer to pages 3 & 6 .
4 . Select a location for the inside antenna . Try to choose a position in the center
of the area needing improved signal . Keep in mind that proper inside antenna
to outside antenna isolation is necessary for the system to function properly .
This may require as much as
50 to 75 feet of horizontal separation
from the
outside antenna . Vertical separation also helps increase isolation . Alternate
means of isolation are possible . If physical separation is not possible, please
contact Wilson Electronics Tech Support at 866-839-9361 for suggestions on
alternate methods to achieve isolation .
5 . Connect the cable from the inside antenna to the signal booster’s “inside
antenna” connector . Refer to page 6 for more information on running cable .
Keep cable runs as short as possible to reduce signal loss in the system .
6 . Before powering up the signal booster, verify that both the outside antenna and
the inside antenna are connected correctly, and check that all connections are
tight .
Note:
Be careful when plugging the connectors in so as not to bend the
center pins on the connectors.
7 . Power on the signal booster by plugging in the included power supply . If the
lights are not green, please refer to pages 9-11 .
Install Overview
Refer to Installation Diagram on page 3 & 4 . Contact Wilson Electronics Technical
Support Team with any questions at 866-839-9361
.
Wide Band Directional
Antenna 75’ LMR 400
(314411-40075)
Wide Band Panel Antenna
60' LMR 400
(311135-40060)
