- 16 -
Analysis of abnormal state of the automatic self-priming pump
Fault
Cause
Remedy
Pump shuts down, but does
not restart after opening the
valve
Pressure switch abnormal
Check pressure switch
Pressure switch adjustment nut too loose Use tools to adjust in place
Pump will not stop after
idling for 8 minutes
Flow switch is not under voltage
1. Check if the flow switch line is
connected properly
2. Replace flow switch or remove the
debris from the water flow switch
Figure 3
Inlet pipe mustn‘t
be posioned higher
than the pump inlet
WARNING
2
3
5 - 8 minutes
Figure 4
1
Injection hole
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN) WITH REDUCED PHYSICAL,
SENSORY OR MENTAL CAPABILITIES OR LACK OF EXPERIENCE AND KNOWLEDGE UNLESS THEY HAVE BEEN
GIVEN SUPERVISION OR INSTRUCTIONS CONCERNING THE USE OF THE APPLIANCE BY A PERSON RESPONSIBLE FOR
THEIR SAFETY. CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH THE APPLIANCE.
DAMAGED CONNECTING CABLES MUST BE REPLACED BY THE MANUFACTURER, CUSTOMER SERVICE OR A SIMILARLY
QUALIFIED PERSON IN ORDER TO AVOID HAZARDS.
17. DISPOSAL
Proper disposal and appropriate recycling of this product prevents damage to the environ-
ment and dangers to your personal health.
To ensure proper handling, recycling and disposal of the used products in question, please
note the following points:
- Only hand over these products at designated, certified collecting points.
- Observe the locally applicable regulations!
Please consult your local municipality, the nearest waste disposal site, or the dealer who
sold the product to you for information on proper disposal.
- The product must not be disposed of with household waste!
Summary of Contents for PW BOOST INITIAL 250EA
Page 75: ......
