en
Installation and operating instructions • Drive for Wilo-Helix2.0-VE / Wilo-Medana CH3-LE • Ed.01/2022-06
43
Universal
Display text
1.1.3 Kp
Parameter Kp
1.1.4 Ti
Parameter Ti
1.1.5 Td
Parameter Td
1.1.6
Controller inversion
1.1.7
Emergency operation mode
1.1.8
Emergency operation speed
1.1.9
Setpoint source
1.1.9 / 1
Internal setpoint
1.1.9 / 2
Analog input (AI2)
1.1.9 / 3
CIF module
1.1.10
Substitute setpoint
1.1.15
Pump ON/OFF
•
Setting the setpoint PID
When the menu item is selected, the setpoint can be set.
NOTICE
The setpoint can only be set if the setpoint source is set to "Internal set-
point"
(see Setting the setpoint source).
Control settings
Parameter Kp
Parameter Ti
Parameter Td
•
Setting the parameter Kp
When selecting the menu item, the desired Kp can be set.
•
Setting the parameter Ti
When selecting the menu item, the desired Ti can be set.
•
Setting the parameter Td
When selecting the menu item, the desired Td can be set.
•
Setting the Controller Inversion
When selecting the menu item, it’s possible to choose PID control mode with “inversion
OFF” or “inversion ON”
•
Setting the emergency operating mode
In the event of a fault, the failure of the required sensor, an emergency mode can be
defined.
When the emergency operation mode menu item is confirmed, you can choose between
Pump OFF and Pump ON. When selecting Pump ON, another menu item “Emergency
speed” appears. The emergency speed can be set here.
•
Setting the setpoint source
Sources can be selected between “Internal setpoint “, “Analogue input AI 2” or a CIF mod-
ule.
NOTICE
A CIF module can only be selected as a setpoint source if a CIF module is
installed. If no CIF module is installed, the menu item cannot be selected
(‚greyed out‘).
If the setpoint is selected via the "Analogue input AI 2", the analogue input
can be set via the Settings menu.
If an external setpoint source is selected (analogue input or CIF module), the menu item
"substitute setpoint" appears. A fixed setpoint can be specified here, which is used for the
control in the event of a failure of the setpoint source (e.g. cable break at the analogue input,
no communication with the CIF module).
10.2.5
Constant pressure p-c specific
parameter
With selection of the control mode ‚Constant pressure p-c the following parameters are
adjustable:
