Installation and operating instructions Wilo-ElectronicControl
24
English
6.3.2 Manual mode
We can access to this mode via the push-button
. The led
is off.
This mode is fugitive and you shall keep pushing on the push-button
to get
it working.The pump starts at maximum frequency. When releasing it the pump
slows down up to complete stop.
6.3.3 Automatic mode
This mode allows an automatic setting of the pressure whatever the flow is.
You can access to this mode by pushing on the push-button
. The led
is
on.
The working condition of this mode can be set in the SETTINGS menu.
7 Installation and electrical connection
DANGER! Risk of death!
An improper installation and electrical connections can result in a risk of fatal
injury.
• The installation and electrical connections should only be done by a qualified
electrician and in compliance with the regulations in force.
• Follow all accident prevention regulations!
• Before installation and electrical connection, switch off the product/station
shall (no voltage) and be sure it cannot be switched on again without any
control!
• Disconnect the mains plug!
PUMP CYCLES
30
PUMP CYCLES
Total number of pump
cycles, one cycle
includes one start and
onr stop.
POWER ON
30
POWER ON
Number of Electronic-
Control switching on
MAX PRESSURE
0,0 BAR
MAX PRESSURE
Storage of the maxi-
mum pressure reached
in the installation (bar).
ALARM COUNT
SHT CIRCUIT
15
ALARM COUNT
SHT CIRCUIT
Total number of short
circuits
ALARM COUNT
OV CURRENT 10
ALARM COUNT
OV CURRENT
Total number of over-
currents
ALARM COUNT
OVER T
5
ALARM COUNT
OVER T
Total number of
exceeding
temperatures
ALARM COUNT
DRY RUN
6
ALARM COUNT
DRY RUN
Number of dry running
Display
Menu level 1
Menu level 2
Description
1_Wilo-ElectronicControl.book Seite 24 Montag, 11. Juli 2011 3:14 15
