Wilo DrainLift WS 40, Installation And Operating Instructions Manual

Page: 42 / 124

en Transportation and storage
42 WILO SE 05
ƒ
Floor fixation
ƒ
Operating and maintenance manual
4.5 Accessories
ƒ
Pump chamber extension
ƒ
Clamp bolting
ƒ
Gate valve
ƒ
Inlet set (gasket and hole saw)
ƒ
Diaphragm hand pump
ƒ
Switchgear
ƒ
Float switch
ƒ
Level sensor
ƒ
Zener barrier
ƒ
Ex cut-off relay
ƒ
Alarm switchgear
ƒ
Flash light
ƒ
Horn
5 Transportation and storage
5.1 Delivery
After receiving the shipment, this must be checked immediately for defects (damage,
completeness). Defects must be noted on the freight documentation! Furthermore, de-
fects must be notified to the transport company or the manufacturer immediately on
the day of receipt of shipment. Subsequently notified defects can no longer be asser-
ted.
5.2 Transport
DANGER
Risk of fatal injury if the load is incorrectly secured!
Faulty or incorrect load securing can lead to life-threatening situations! Secure the
load in accordance with local regulations. Check the load is secure before transport!
WARNING
Standing under suspended loads!
Never allow anyone to stand under suspended loads! Danger of (serious) injuries
caused by falling parts. Loads may not be carried over work places where people are
present!
WARNING
Head and foot injuries due to a lack of protective equipment!
Danger of (serious) injuries during work. Wear the following protective equipment:
• Safety shoes
• Safety helmet must be worn if lifting equipment are used!
NOTICE
Use only properly functioning lifting equipment!
Use only properly functioning lifting equipment to lift and lower the pump chamber.
Ensure that the pump chamber does not become jammed during lifting and lower-
ing. Do
not exceed the maximum bearing capacity of the lifting equipment! Check
that lifting equipment is functioning properly before use!
To avoid damage during transport, please observe the following points:
ƒ
Always transport the pump chamber on a pallet.
ƒ
Always set down the pump chamber vertically on the pallet.
ƒ
Secure the pump chamber against slipping. When lashing, make sure that the plastic
parts do not deform.
ƒ
Close any openings, ensuring they are sealed watertight.
ƒ
Remove loose accessories from the pump chamber and pack them separately.