11
centered side to side with the keel as possible. The control bar apex bracket will slide on the
keel track until it comes up against the stop at the forward end of the track. If the apex
slider resists sliding forward, wiggle the basetube back and forth slightly to free it.
STOP: If the apex bracket will not slide forward, check to see that a bottom side
wire is not hooked around the head of the keyhole bolt at the rear wire station
on the keel.
5) Insert the rounded end of the swan catch lever (without the thumb handle extension) into
the rear pin channel in the swan catch bracket on the bottom of the noseplate. (The pin
should be retracted and held in place by the flat swan spring. If it is not, retract the pin first).
As the swan lever end depresses the flat swan spring, the spring loaded swan catch pin will
be released. Align the hole in the lever with the pin, and allow the pin to slide through the
lever and through the other side of the swan catch channel.
