9
RE-MOUNTING THE REAR LEADING EDGES
1) Make sure you are mounting the correct leading edge rear into the correct front (check
the “right” / “left” designation.
2) Spray the forward six inches of the rear leading edge with silicone spray lubricant.
3) Slide the rear leading edge into the front, lining up the rotational alignment marks you
made during breakdown, until the rear engages fully in the front leading edge, as indicated
by the circumferential scribe made at the exit point of the rear leading edge during break-
down.
4) Pull the sail down the leading edge and re-install the mylar if removed. The mylar is most
easily installed by attaching it to a long pole and pushing it into the pocket.
5) Re-install the top side wire if removed.
6) Remount the sail to the rear leading edge, making sure to align the
sail mount webbing
squarely in the slot and attach the securing velcros.
STOP: THE SAIL IS MOUNTED TO THE LEADING EDGE BY THE INNER (FOR-
WARD) OF THE TWO LOOPS OF WEBBING. THE OUTER LOOP IS A PULL
HANDLE ONLY.
You may find it helpful to use a large, flat bladed screw driver to pry the sail mount webbing
over the end of the leading edge tube and into the slot. Take care not to damage the web-
bing.
