Will Burt Inflexion Plus 1.8, Operating Instructions Manual

Page: 56 / 104

PAGE 54 OF 102
INFLEXION PLUS
OPERATING INSTRUCTIONS
TP-5211901-C
JUNE 2021
6.6 Initiating (Power-Up)
Perform the following to power up the system:
1. If the “E-Stop” was activated during prior use, it must be reset by turning to enable the system
to power-up. Do not reset the “E-Stop” until the cause of the event is corrected. Turn the red
“E-Stop” button if needed.
2. Press "NFPA Start" to power-up the mast.
On initiation, the Base Board establishes communication with the other boards in the system. If
communication cannot be established, an error code is shown on the display and the
communication system is shut down. The HHRC must be connected prior to power-up to be
recognized by the controller.
The PositionIt™ will move off its saddle to bring the tilt plate in a horizontal position upon
initiation.
6.7 Raising the Mast to 90°
The mast uses a DC powered actuator to drive the mast from stow to 90°. When at 90°, a
proximity sensor detects the actuator then drives the actuator a bit further. Driving the actuator a
bit further causes the mast to seat firmly into the rubber mast pad. Do not overdrive the actuator
or damage to the system could occur. Once the mast is at 90°, all remote control functions are
available.
There are two ways to raise the mast to 90°.
• Use the Auto-Up feature.
• Press and hold the "Mast Up" button.
There are several advantages in using the Auto-Up feature to raise the mast to 90°:
• The Auto-Up feature automatically moves the mast to 90°, whereas the "Mast Up" method
requires the operator to press the controls throughout the process.
• The Auto-Up feature allows the system to check its switches and better determine the 90°
position.
The Auto-Up feature is the quickest and most reliable method to raise the mast to 90°.