Will Burt Inflexion Plus 1.8, Operating Instructions Manual

Page: 43 / 104

PAGE 41 OF 102
INFLEXION PLUS
OPERATING INSTRUCTIONS
TP-5211901-C
JUNE 2021
5.7 Electrical Installation
Refer to the wiring diagrams in the Appendix section for electrical connections. These diagrams
are also available at www.willburt.com. Be sure to follow the torque requirements shown on the
wiring diagram. See 5.7.1 for wiring access panel. To electrically connect the mast system,
proceed as follows:
1. Remove the screws from the left cover of the base (as viewed from the back of the unit) and
remove the cover.
a. For models 1.8 and 2.3, run the Bulkhead Cable from the HHRC connected to the
bulkhead or the PMRC Control Cable into the bottom of the base.
Figure 5-8 Models 1.8 and 2.3 Access Holes
b. For models 4.5, 6.0, and 7.5, run all power/data cables connected to the bulkhead into
the interface panel (Figure 5-9).
Figure 5-9 Models 4.5, 6.0, and 7.5 Interface Panel (Only interface panel shown)
Access Holes
Light Power Cable
Grommet
DC Board Power
Controller Cables Mast Active
Ø Range 0.71-0.98 in
(18-25 mm)
Signal Ø Range 0.39-0.55 in
(10-14 mm)
Ø Range 0.39-0.55
(10-14 mm)
Auxiliary Access
(if needed)
Ø1.75 inch hole
(44 mm)
Fitting (1/4” NPT)
1/2” Diameter Hose
Fitting (1/4” NPT)
3/8” Diameter Hose