The booster is made with water-proof material and available to mount on a
tree or any outdoor applications with the attached belt as the installation
method shown below. The light window must always be required toward to
the scounting target by adjusting the booster unit angle. An easy way to
do that while a booster is mounted on tree already, you try to add a proper
short stick behind the
booster and adjust it
’
s
position to the belt
obversely.
If you will use a
booster for indoor
security application, it is
also available to be
upside down mounted on
a ceiling with a popular mounting accessory. But any upside
down installation methods will NOT be applied for OUT-DOOR
used.
Transmitter Setup
See the out-look with IR sensor at
Fig.5
. It will compatible
with all of general night vision scouting camera. It is
recommended to place the camera and booster apart not
more than 50 feet which a consideration about an animal
target away from the camera will be too smaller in case out
of this range. Then, just snap the transmitter
(Fig.3)
on belt
and place it near to the side where closely to the IR light source of camera. Press the TEST button and see the
TRANSMIT light must be fully ON. It means the battery status to be good and a RF trigger signal is sending to