Since above installation is done, no more adjusting will be required. Slide the PW SW of Booster to
ON
. Now,
the system is start working on duty at night time and silent at day. It always does synchronize with your
scouting camera or CCTV for each event. It only consumes a very low power at stand-by mode. So that it will
stay in the field for a long time and the average life under good quality battery will be able for taking more than
a few thousand images under normal conditions.
Caution: Pay attention to avoid the Day/Night sensors on the transmitter to be covered. See Fig.5
After installation procedures and distance Self-test are done, do not forget to check if the slide
panel on transmitter is closed completely; PW knob is switched to ON and the other rest port is still
remaining corked by a spile before left.
Advanced Usage
Change for New Work Group
If you would like to add more wireless boosters to work at a time to get more illumination, you can place
unlimited
IR boosters
with a same coding to group together under one transmitter. Then allocate all
boosters around the target position and repeat a same test as above to request all units will work at a same
time. If you find there is a jamming signal appearing around you to cause either one booster to work
improperly, just simply to change the WORK GROUP code for a new coding on both transmitter and all boosters
in order to make your system difference than your neighbor.
Caution: The multiple codes of user defined are available for user. Just remember to change the same code
applied for all boosters and transmitter. You may do this in case there is more than one user to use the same
system around your neighborhood.
Video Phase Setting:
Sometimes, you might wonder about a dark bar which is frequently scrolling trough the video clips. There is
a knob called "Video Phase" on inner panel. You can adjust it to make the pulsing frequency to be synchronized
as your camera at video mode in order to stop the scrolling bar
Adjusting Method
: