17
Removal and replacement of the front glass panel.
The glass panel is held in place with 8 screws and 3 nuts.
When removing the screws it is advised to remove the 3 nuts
first, then the 6 side screws, and finally the top two screws.
Take care to hold the glass panel whilst removing the final
screw.
Take care to support the glass and the frame when removing
or handling the glass assembly.
Now liI the glass frame assembly from the appliance.
The ceramics can now be installed, rearranged correctly or
removed for service. For correct installa"on of ceramics see
pages 24-27
.
Refit the glass frame assembly in the same manner.
The glass panel should be undamaged. If the glass panel is
broken or cracked it should not be used. Contact the
manufacturer for a suitable replacement before connuing.
Installaon / Removal of the Front Trim.
Fit the marble/stone access cover into posion. See
page 10.
The front trim can now be fixed to the appliance.
Place the lower edge into posi"on on top of the marble
access cover ensuring the control lever pokes through the
lower slot in the trim. Now rotate into posi"on. The front
face of the trim should be in line with the front of the mantel
and access cover.
Correct alignment can be achieved by removing and adjus"ng
the 4 (four) screw magnets on the trim.
The gap between the top of the trim and the mantel can also
be adjusted using the two thumb screws at the base of the
trim. See above.
It is important to leave about 1-2mm above the
trim as expansion will take place while the
appliance is hot.
GLASS PANEL / FRONT TRIM INSTALLATION
Adjustment of the Front Trim.
The front trim has various adjustment features to allow it to
sit in the correct posi"on.
On the rear of the trim are 4 (four) screw in magnets. These
magnets sit on the glass frame and can be adjusted to align
the front face of the trim with the front face of the mantel.
At the lower edge of the trim there are two thumb screws
which can be wound in and out to set the height of the trim.
These screws will sit on the marble access cover and create a
small gap in this area. Subsequently this will control the gap at
the top of the trim/mantel.
