6
Unpack the appliance carefully from the packaging. This product is supplied in TWO cartons.
Ensure it is not damaged and that all of the components are included. The cartons should include:
1a
Appliance and (Trim is fiMed to the appliance) - See below for trim removal instrucons.
1b
Ceramic pack (Behind the glass) - See below for glass door opening instrucons.
1c
Tool and fi8ng pack—Includes 2 tools and seal grommet and fi8ngs required for installaon.
1d
Rear and side glass panel pack
1e
Instrucon and Warranty pack.
2a
Flue Pipe (Inner and Outer)
2b
Terminal Mounng Plate
2c
Terminal
2d
Terminal Guard
2e
Screw & Fi8ngs Pack.
DO NOT ATTEMPT TO REMOVE THE TRIM BEFORE
READING THESE INSTRUCTIONS
The trim is securely fastened to the appliance and must
be removed using a Philips headed screwdriver.
Using an appropriately sized Philips headed screwdriver,
carefully unscrew the two screws visible between the gap
between the trim the side of the glass door. Once these
screws are removed the trim can be carefully pulled away
from the appliance.
Put the trim in a safe place for the
remainder of the installa:on to avoid causing damage.
PREPARING THE APPLIANCE FOR INSTALLATION
Using the 90 degree short Allen key
from the tool-pack, insert into the
hex bolts at the top edge of the glass
door. Rotate these bolts (one is top
le, the other is top right) about a
quarter
turn
and
the
door
mechanism will release.
Rotate the le hand bolt clockwise
and the right hand bolt an-
clockwise.
Carefully lower the door open unl it
reaches the stop.
Remove the ceramic carton and the
glass carton from the combuson
chamber and put in a safe place
whilst the installaon connues.
OPENING THE GLASS DOOR
REMOVING THE TRIM & OUTER TRIM
