Wilbar Optimum Pool Round 95-0770, General Instructions Manual

Page: 27 / 51

Section 2
Step 3
– Wall Installation (Continued)
25
3.3 Slide two 52” Splines (#77002) into compression seams to
lock both panels together.
If inserting the Splines is difficult:
• Apply cooking oil to lubricate and ease installation.
• Ensure a 1/8” gap between both panels is uniform top to
bottom.
• Check Splines and seams are free of any sand or
debris.
Repeat this step with all remaining panels.
3.4 Assemble shorter Filler Panels on each side of the void
where the step will be placed using two 52” Splines and an
Anchor Plate (#77004).
Note: shorter Filler Panels must be located on each side of
the step.
3.4
3.3
Section 2
FULLY IN-GROUND WITH POLYMER STEP
FULLY IN-GROUND STEP