
IP Address
Enter the IP address of the VPN server. Clients will
connect to this IP from remote sites.
Netmask
Enter the subnet mask.
LAN Profile
Select the LAN profile on which the VPN server
will run.
Advanced Options
Tick-off the checkbox to enable advanced options.
Public Server Certificate
Enter the public server certificate.
CA Certificate
Enter the CA certificate.
Private Server Key
Enter private server key.
Enable TLS Authentication
If enabled, TLS authentication is enabled.
TLS Auth Key
Enter
the
authentication
key
for
TLS
authentication.
Masquerade (NAT)
Tick the check-box for the server to enable
masquerading of the packets.
Force Default Route
Tick the check-box if the server should force the
traffic on default IP route.
Table 2.6
When all the details are carefully filled in, click on the ‘Submit’ button.
2.7 Monitoring
The UniBox monitors each configured device periodically, then alerts the admin if there is an outage. UniBox
uses the MAC address of the device for monitoring as the IP address of the device may change if the device
is on a dynamic IP. Also, MAC address monitoring is more reliable. The admin is required to enter the MAC
address of the interface that will be connected to the UniBox for monitoring.
2.7.1 Create / New Monitoring Device
An admin is facilitated with the services that allows him/her to configure a new device for monitoring. If the
UniBox is used within a wireless network, then admin can configure the devices in UniBox for monitoring.
UniBox will check the status of all devices periodically and will send email alerts if any of them are down. The
UniBox can monitor devices, both on LAN and WAN side. LAN side devices are monitored using their MAC
address while the WAN side requires the IP addresses.
UniBox runs a monitoring process that will periodically check the status of all access points. Admin can
configure one or more email addresses for notification.
To add a new monitoring device, go to the ‘Network’ module followed by the ‘Monitoring’ section. Then, click
on the ‘
+
’ icon, a modal form appears to gather information required to add a new device for monitoring.
Summary of Contents for Unibox
