Page 20
Deck oven
It is advisable to transport the device or the combined installation in the horizontal position. If it proves
necessary to dismount the devices from the combined installation to transport them in the vertical posi-
tion, you must observe and comply with the following information:
1. Remove the stone baking plates from the device.
2. Wrap the stone baking plates in suitable material to prevent them being damaged.
3. Tip the individual device to the opposite side of the controller.
=> The controller must be at the top.
4. Use suitable carrying straps for transportation.
Component
Description
1. Dismounting/ 2. Assembly
Support material Figure
Extractor
hood
1. Loosen the M5 (A) screws in the
back area of the extractor hood.
Push the extractor hood backwards
and take off the device upwards.
2. Put the extractor hood on the
front screws on the oven. Push hood
forwards and screw it tight using the
screws (A).
Allen key 2.5
Ebo
124 / 128
1. The device is attached to the next
one using four M6 hexagonal screws
(S).
Loosen the screws and take off the
device upwards.
2. Place the device and screw it tight
using four M6 screws.
Socket wrench
SW 10
Base frame
1. The device is attached to the next
one using four M6 hexagonal screws
(S).
Loosen the screws and take off the
device upwards.
2. Place the device and screw it tight
using four M6 screws.
Socket wrench
SW 10
Prover
1. The device is attached to the next
one using four M6 hexagonal screws
(S).
Loosen the screws and take off the
device upwards.
2. Place the device and screw it tight
using four M6 screws.
Socket wrench
SW 10
3.3. Dismounting/mounting the combined installation, Ebo 124 / 128
A
S
S
