3- Optional Landing Gear Installation
Step 1
– Locate your 2-7 ½” 2mm landing gear rods. Mark a spot for the landing gear ¾ “
back from the servo slot and 1 ½” up the vertical fuse as shown in the picture above. You can
either make a ½” vertical slice through the fuselage here or sharpen the landing gear rods
and push them through the EPP. Push the landing gear legs into the wing 1” from the
fuselage as shown and about ¾ of the way into the EPP and glue. While the glue is still wet
you can flip the plane over and check for level. Slightly push in or pull out the individual legs
until you are level. Once satisfied, glue the legs in at the wing and fuselage.
