Step 11
–
Fit your aileron servo into the cut servo hole and check for fit. It should fit snugly.
Trim as necessary as shown above. Once you have a good fit you can thread the wire
through the hole so that the connector is on the side with the carbon fiber truss bracing. Now
put a small dab of glue on the servo tabs to hold it in.
Step 12
– Trim 1/8” off of the front of the
3 rearward tabs on the top fuselage.
When installed the front of the top
fuselage should be flush with the
horizontal fuselage where the motor
mounts.
