33740-11-0816
3DJH
/RFNRXW6WDWH'H¿QLWLRQ
A lockout state is reached when an ignition error occurs. The
lockout state will remain set in memory as long as the power sup-
plies are applied.
7KLVFRXOGPHDQERWKDQLUUHJXODUÀDPHGHWHFWLRQDQGRUWRR
many unsuccessful ignition attempts.
This state is a safe condition for the appliance and is entered
automatically by the IFC board.
When the IFC board gets into lockout state:
1. both the Pilot and the Main Burner solenoids in the gas valve
are de-energized;
2. a diagnostic code is sent through the diagnostic red LED.
3. the IFC board will ignore any burner ignition command and
remain in the OFF state unless the unlock command se-
quence is met.
The causes of lockout must be investigated under safe conditions
E\WKHXVHUDQGRUWKHVHUYLFHSHUVRQQHO
To reset the IFC from a lockout state, perform the following pro-
cedure:
Turning the system power supplies (to the wall control or
remote control) OFF for two or three seconds and then
restoring a power supply back on.
The return of the system to normal operation must be checked
XQGHUVDIHFRQGLWLRQVE\WKHXVHUDQGRUVHUYLFHSHUVRQQHO
Using the Fireplace without a Remote Control
7KH¿UHSODFHFDQEHW,RQO\DQG2))ZLWKWKHZDOO
VZLWFK7KH¿UHSODFHÀDPH212))LVWKHRQO\IXQFWLRQWKDWZLOO
RSHUDWHQRÀDPHDGMXVWPHQWOLJKWRUEORZHUZLOOZRUNZKHQXV
-
ing the wall switch. The wall control switch should be turned OFF
ZKHQWKH¿UHSODFHLVQRWEHLQJXVHGIRUH[WHQGHGSHULRGVRIWLPH
Battery Backup Operation
Install batteries (See initialization sequence on page 44). In case
RISRZHUORVVWKH¿UHSODFHZLOOVZLWFKWREDWWHU\PRGHDXWRPDWL
-
FDOO\7KH¿UHSODFHZLOORSHUDWHQRUPDOO\ZLWKRXWWKHIDQRUOLJKW
control when in battery mode.
Low Battery Detection
When the backup batteries are low, a double-beep will be emitted
ZKHQWKHPRGXOHUHFHLYHVDQRQRIIFRPPDQG1RFRPPDQGV
ZLOOEHDFFHSWHGXQWLOWKHEDWWHULHVDUHUHSODFHGRUWKH$&SRZHU
is restored.
MULTIFUNCTION REMOTE OPERATING INSTRUCTIONS