You can level your machine by adjusting its feet.
First, loosen the plastic adjustment nut away from the cabinet base.
Change the level by adjusting the feet upwards or downwards.
When the machine is level and stable, tighten the plastic adjustment nut again by
rotating it upwards against the base of the cabinet.
Never put cartons, wooden blocks or similar materials under the machine to
balance irregularities of the floor.
ELECTRICAL CONNECTION
Your washing machine requires a 50Hz supply of 220-240V.
A special earthed plug has been attached to the supply cord of your washing
machine. This plug must be fitted to an earthed socket. The fuse value fitted to this
plug must be 13A. If you have any doubts about your electrical supply, consult a
qualified electrician.
Insert the machine’s plug into an earthed socket which you can easily reach.
WARNING: This appliance must be earthed.
WATER SUPPLY CONNECTION
Your machine has a single (cold) water inlet.
To prevent leakage from the connection joints, a rubber washer is included in the
hose packing. Fit this washer at the end of the water inlet hose on the tap side.
Connect the hose to the water inlet valve at the rear of the machine and the other
end to your tap. Tighten the plastic connector by hand. Please calI a qualified
plumber if you are unsure about this.
Water pressure of 0,1-1 MPa from your tap will enable your machine to work more
efficiently. (0,1 MPa pressure means water flow of more than 8 litres in 1 minute
from a fully opened tap)
After connection is complete, check for leakage by turning on your tap completely.
Ensure that the water inlet hose is not folded, broken or crushed, when the
washing machine is in its final position.
Connect the water inlet hose to a 3/4” threaded water tap.
4
