If you plan not to use your machine for a long time, unplug it, shut off the water
supply and leave the door open in order to keep the inside of the machine dry and
to prevent unpleasant odours in the drum.
As a result of our quality control procedures, a certain amount of water may remain
in your machine from testing. This is not harmful for your machine and is perfectly
normal.
SECTION 2: INSTALLATION
Please pay attention to the following issues before using your washing machine for the
first time.
REMOVAL OF TRANSPORTATION SCREWS
The 4 transportation screws, which are located at the back of the machine, must
be removed before running the machine.
Loosen the screws by turning them anti-clockwise with a suitable spanner.
(DIAGRAM-1)
Pull out the screws, rubber washers and plastic spacers. (DIAGRAM-2)
The holes where the transport screws have been removed should be covered with
the plastic transport caps found in the accessories bag. (DIAGRAM-3)
The transportation screws that have been removed from the machine must be re-
used in any future transporting of the machine.
DIAGRAM-2
DIAGRAM-1
DIAGRAM-3
FOOT ADJUSTMENT
Do not install your machine on rugs or similar surfaces.
For your machine to work silently and without any vibration, it should be installed
on a flat, non-slippery, firm surface. Any suspended floor must be suitably
strengthened.
3
