20
Maintenance
CHANGE COLLET AND O-RING
1
. Remove the collet and o-ring from the fitting with a small
screwdriver. Do not scratch the internal walls of the collet
port. See Figs. 26 & 27.
2
. Clean collet port, lubricate with silicone-based lubricant,
and insert the o-ring seal into the bottom of the port. See
Figs. 26 & 27.
3
. Push the collet inward until it locks in place. See Figs. 26
& 27.
Change Collet and O-Ring
FIG. 26
Collet
Fitting
O-Ring Seal
Push o-ring seal into
bottom of port then
follow with collet.
Disconnect Tubing
FIG. 27
Tubing
Collet (depress to
remove tubing)
NOTE: It is not recommended that the RO assem-
bly be opened. If this becomes necessary, pay
careful attention to the layout of the parts and the
routing of the tubing. It will be necessary to
assemble the unit exactly as shown for the system
to fit together and function properly.
FIG. 28
