13
Step F - Connect Tubes
HOW TO CUT AND CONNECT THE TUBES
Your Reverse Osmosis system includes push-in fittings
for quick tubing connection. Review the following
instructions before connecting the tubes in the next
step. Failure to follow these instructions may lead to
future leaks.
Cut tubes to length
1
. Use a sharp cutter or knife to cut the end of tubing.
Always cut the tubing square. See Fig. 16.
2
. Inspect the tube up to 1” from the end to be sure
there are no nicks, scratches or other rough spots. If
needed, cut the tubing again. See Fig. 16.
Connect tubes
1
. Push tubing through collet, until it engages the o-
ring. See Fig. 17. Continue pushing until the tube
bottoms out against the back of the fitting. See Fig.
18. Do not stop pushing when the tube engages the
o-ring. Failure to follow these instructions may lead
to future leaks. When a 1/4” tube is fully engaged,
11/16” of the tube has entered the fitting. When a
3/8” tube is fully engaged, 3/4” of the tube has
entered the fitting. Mark tube with a piece of tape or
marker. See Figs. 17 & 18.
2
. If additional tubing is required, see parts list at the
end of this manual.
To Disconnect Tubes
1
. Push the collet inward with a finger tip. See Fig. 20.
2
. Continue holding collet inward while pulling the tub-
ing out. See Fig. 20.
Push-in Fitting
Tube
Tube Correctly Cut
FIG. 16
Cut tubing square with end of tubing round,
smooth, with no cuts, nicks or flat spots.
Tube Partially Engaged with Fitting
FIG. 17
Collet
O-Ring
Tube Fully Engaged with Fitting
FIG. 18
Collet
O-Ring
Collet and O-Ring
FIG. 19
Collet
Fitting
O-Ring Seal
Disconnect Tubing
FIG. 20
Tubing
Collet (depress to
remove tubing)
