16
Step G -
Sanitize, Test and Purge System
(cont.)
Storage
Tank
HOT COLD
FIG. 23
Reverse
Osmosis
Faucet
Kitchen
Faucet
PRESSURE TEST THE SYSTEM
NOTE: Complete the sanitizing procedures on the
preceding page before pressure testing.
To pressure test the system, complete the following
steps.
1
. Open the water supply valve(s) that you closed
before installing the Reverse Osmosis system.
2
. Purge air from the plumbing by opening the sink
faucet(s). Close faucet(s) when water runs smooth,
with no spurting.
3
. Pressure will start to build in the RO system. In
about 2 hours check all fittings and connections.
Check for water leaks. Fix leaks if any are found. If
problems exist, refer to the troubleshooting chart or
call the toll free number below).
NOTE: When the system is first pressurized, water
may ''spurt'' from the faucet air gap hole until air is
expelled from the RO system.
Please review the following operating features
before using your Reverse Osmosis system:
NOTE: As with all other water system applications,
leaks may occur. Because the system pressure
builds slowly, leaks may not be immediately appar-
ent. Recheck for leaks 24 hours after purging the
system is complete.
PURGING THE SYSTEM
To purge the system, complete the following steps.
1
. Open the Reverse Osmosis Faucet and let water
flow through the system for a 24 hour period. Water
flow will be a slow trickle at this time.
NOTE: Do not consume water from the RO sys-
tem until purging is complete.
2
. Close the Reverse Osmosis faucet after the 24 hour
purging period is complete.
3
. When the purging is finished, your Reverse
Osmosis system is ready for use.
You will
not
have filtered water immediately. It may
take several hours to fill the storage tank and create
maximum flow from the Reverse Osmosis faucet.
Water will run to the drain while the Reverse
Osmosis system is producing water, even if you are
not drawing water from the Reverse Osmosis faucet.
You may hear a small quantity of water going to the
drain at times when water is not being used. This is
normal. Water going to the drain will automatically
shut off when the storage tank is full.
Water Pressure from the Reverse Osmosis faucet will
be less than your standard faucet.
Cold Water
Supply
Water Supply Shutoff
Valve to Reverse
Osmosis System
