Whirlpool LEW0050PQ - Electric Dryer, Job Aid And Service Manual

Page: 18 / 48

2-10
WARNING: To reduce the risk of fire, this dryer
MUST BE EXHAUSTED OUTDOORS.
4
″
(10.2 cm) heavy metal exhaust vent and
clamps must be used. DURASAFE
™
vent prod-
ucts are recommended.
DURASAFE
™
vent products can be purchased
from your dealer, or by calling Whirlpool Parts
and Accessories.
• The dryer exhaust must not be connected
into any gas vent, chimney, wall, ceiling, or a
concealed space of a building.
• Do not use an exhaust hood with a magnetic
latch.
• Do not install flexible metal vent in enclosed
walls, ceilings or floors.
• Use clamps to seal all joints. Exhaust vent
must not be connected or secured with screws
or other fastening devices which extend into
the interior of the duct. Do not use duct tape.
VENTING REQUIREMENTS
WARNING
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions can
result in death or fire.
Improper venting can cause moisture
and lint to collect indoors, which may
result in:
• Moisture damage to woodwork,
furniture, paint, wallpaper, carpets, etc.
• Housecleaning problems and health
problems.
IMPORTANT: Observe all governing codes
and ordinances.
Use a heavy metal vent. Do not use plastic or
metal foil vent.
Rigid metal vent is recommended to prevent
crushing and kinking.
Flexible metal vent must be fully extended and
supported when the dryer is in its final position.
Remove excess flexible metal vent to avoid
sagging and kinking that may result in reduced
airflow.
An exhaust hood should cap the vent to pre-
vent rodents and insects from entering the
home.
Exhaust hood must be at least 12
″
(30.5 cm)
from the ground or any object that may be in the
path of the exhaust (such as flowers, rocks or
bushes, etc.).
If using an existing vent system, clean lint from
the entire length of the system and make sure
exhaust hood is not plugged with lint. Replace
any plastic or metal foil vent with rigid metal or
flexible metal vent.