【
Air Exhaust
】
*
To remove the wire, please use a screwdriver and turn the screw out and pull the wires.
Please avoid the following situations when installing the exhaust pipe.
【
Electrical engineering – wiring
】
1.Over bending
2
.
Bending too much 3.
(
Minimum 200mm)
The bend of the pipe
comes too close to
the main body
4.
The bend shrinks
Main Body
To remove the wire, please use
a screwdriver and turn the screw
out and pull the wires.
L(220V~)Live Line
N(220V~)Zero Line
*the diameter of the wire should be no less than 1.5 mm .
Wireless Remote Control
Main Body
2
-
10
-
1) Over bending.
2
)
Bending too much.
3) The bend of the pipe comes too close to the main body.
4) The bend shrinks
.
1) Please prepare the unique air switch for this product in the user’s house ,
the air switch should be consistent with air switch off contact all
disconnected requirements of distance is greater than 3 mm.
power of the product immediately in case of accident.
2) Installation and wiring of power must be performed by qualified electrical
engineering contractor.
3) Please use this product under rated voltage and rated frequency in accordance
with the product nameplate.
4) When installing, the fixed power wiring must be in accordance with local safety
regulations.
5) This product does not provide the power cord and plug or other disconnecting
device.
6) For metal net bottom, steel wire net bottom of walls or wooden houses with the
metal surface , etc when install metal duct through , do pay attention that there
shall be no electrical contact.
7) When the Power supply is insufficient, conduct with electric power supply company.
8) Prior to the opening front panel, please make sure that the machine is powered off.
and let
extremely
In order to cut off the
