background image

Installation & Control Guide for 

SL Wireless Controlled Plinth Heaters 

 
 

PHSL2 & PHSL3 SERIES 

 
All electrical appliances produced for the Company are guaranteed for one year 
against faulty material or workmanship.  This applies only if the appliance has been 
used for purposes in accordance with the instructions provided and has not been 
connected  to  an  unsuitable  electricity  supply,  or  subject  to  misuse,  neglect, 
damage or modified or repaired by any person not authorised by us. This guarantee 
is offered to you as an extra benefit and does not affect your legal rights. 
 
The correct electricity supply voltage is shown on the rating label attached to the 
appliance. 
 
Reasonable care has been taken to ensure that this guide is accurate at the time 
of  printing.  In  the  interest  of  progress  the  Company  reserve  the  right  to  vary 
specifications from time to time without notice.

 

Q

UALITY

 S

PACE

 H

EATERS

 

68000828  Iss 01 

Summary of Contents for PHSL2 Series

Page 1: ...uitable electricity supply or subject to misuse neglect damage or modified or repaired by any person not authorised by us This guarantee is offered to you as an extra benefit and does not affect your legal rights The correct electricity supply voltage is shown on the rating label attached to the appliance Reasonable care has been taken to ensure that this guide is accurate at the time of printing ...

Page 2: ...y a competent electrician The heater carries a Do Not Cover label to warn the user that if the appliance is covered there is a risk of overheating Cleaning Always disconnect the heater from the mains before cleaning The heater should not require any maintenance but it is strongly advised that it is kept clean An occasional wipe over with a soft cloth is all that should be necessary Do NOT use meta...

Page 3: ...e plinth space The cable shall be sufficiently long as to pass through the plinth space and plinth board This enables the appliance to be subsequently withdrawn from the plinth if maintenance is required Ensure no sharp edges are present along the power cable route 3 The appliance can now be slid through the plinth board until the fascia panel abuts the outside of the plinth board Screw the fascia...

Page 4: ...ation This heater can only be used when connected to any SL wireless controller Each SL controller can control any number of heaters providing they are in the RF range SL wireless controllers Please refer to the SL installation and control guide for full operational details SLPB SLTI SLVT Fan Control Switch There is a Fan Control Switch on the facia When the control switch is OFF the appliance blo...

Reviews: